Cleaning the RO Cartridge(s)
When
Cleaning the RO cartridge may be required when feed water contains excess
ation from lipore
of some chemicals.
Pe cleaning if required, after recommend
Ser e R
rform your Mil
vic epresentative.
Safety
Wear Eye Safety Glasses and Laborator
equipment when cleaning the RO Cartridge(s).
y Gloves and other appropriate safety
Cleaning
Follow the steps below to clean the RO Cartridg
Step Action
e(s).
Diagram
1 nitisation port as
described in the previous
section.
Open the sa
2 Place a cleaning agent pouch
(ROClean A or ROClean B)
into the Sanitisation Port.
3 Put the cap back on and hand-
tighten it.
NOTE:
The chemical in the pouch will
dissolve during the pH
Cleaning sequence. Remove
the empty pouch the next time
the Santisation Port cap is
removed.
4 Go to STANDBY Mode.
Continued on next page
!
- 89 -
To Next Page
Loading...
Need help?
General
