Millipore Milli-Q Direct 8 System User Manual

Specifications and requirements
Milli-Q

Water
quality
The water delivered from a POD Unit has the following characteristics.
Parameter Specification Units
Resistivity 18.2
M.cm @25°C
TOC
 5
ppb
Particulates > 0.22 m**
< 1 Particulates/mL
Bacteria** < 0.1 cfu/mL
Pyrogens* < 0.001 Eu/mL
RNases* < 0.01 ng/mL
DNases* < 4
pg/L
Flow Rate** 0.05 – 1.5 L/min
(*) With BioPak

Final Filter
(**) With Millipak

or BioPak Final Filter
NOTE:
These specifications are valid if feed water within specification and if correct
maintenance is performed on the system. Some specifications may not be
achieved at start-up.
Weight
The various weights are found in the table below.
System Operating
Weight (kg)
Dry Weight
(kg)
Shipping
Weight (kg)
Milli-Q Direct 8 27 20 24
Milli-Q Direct 16 28 21 25
Electrical
The electrical specifications and data are found in the table below.
Parameter Value
Voltage
100-230 VAC 10%
Frequency
50-60 Hz 10%
Main Fuse
 3.15 Amp Fast Acting; 5 mm x 20 mm; 250 V
safety voltage.
 The fuse should be serviced by a qualified
Millipore Service Representative.
Power Used 145 VA
Power Cord Length 2.5 metres
Electrical Ground Earth Grounded
Power Cord use
 The System is powered on and off by removing the
power cord from the wall outlet.
 The power cord should be plugged into a wall
outlet that is accessible.
Continued on next page
- 16 -

Millipore Milli-Q Direct 8 System Specifications

General

Brand	Millipore
Model	Milli-Q Direct 8 System
Category	Water Filtration Systems
Language	English