Need help?Do you have a question about the Millipore Milli-Q Integral 10 and is the answer not in the manual?
General| TOC (Ultrapure Water) | < 5 ppb |
|---|---|
| Pyrogens (Ultrapure Water) | < 0.001 EU/mL |
| RNases (Ultrapure Water) | < 1 pg/mL |
| Type of Water Produced | Ultrapure Water |
| Resistivity (Ultrapure Water) | 18.2 MΩ·cm |
| Particles > 0.22 μm (Ultrapure Water) | < 1/mL |
| Bacteria (Ultrapure Water) | < 1 CFU/mL |
| Flow Rate (Ultrapure Water) | 1.5 L/min |
| Feed Water Requirements | Potable water |
| Purification Technologies | Reverse osmosis |
| Display | Color touch screen |
| Connectivity | Ethernet |
| Power Supply | 100-240 V, 50/60 Hz |
| Dimensions (W x D x H) | 40 x 30 x 60 cm |
Explains the intended use and recommended reading of the User Manual for the Milli-Q Integral Water Purification System.
Details the characteristics of the water delivered from the Q-POD Unit.
Provides voltage, frequency, fuse, power usage, and cord details.
Details specific alarms like Tank Empty, Progard Pack Out, and Quantum Cartridge Out.
Step-by-step guide for installing a new Quantum Cartridge.
Procedure for installing a new Progard Pack.
Details the procedure for flushing and rinsing the RO Cartridges.
Explains the procedure for rinsing the Quantum Cartridge.
Procedure for resetting UV lamp timers after installation or replacement.
Procedure for resetting the Inlet Strainer cleaning message timer.
Instructions for cleaning the A10 TOC Monitor.
Step-by-step guide to performing a flow calibration using the Q-POD Unit.
Explains how to enter and use the Manager Menu for system settings.
Lists maintenance tasks for consumables and lamps, indicating when they are needed.
Explains alarm messages, types, and how they are displayed.
Provides a list of LCD alarm messages and their meanings.
Details alert messages, types, examples, and display information.
Lists LCD alert messages and their corresponding meanings.
To Next Page