Milltronics SL10 Series - Page 5

I NSTRUCTION H ANDBOOK
S ERVING THE M ETAL C UTTING I NDUSTRY S INCE 1973
1400 M ILL L ANE • W ACONIA , MN 55387
T EL : 952.442.6455 • F AX : 952.442.6457
Chapter 5 - Failure Modes, Detection and Prevention................................................... 31
Minimizing Wear and Tear .........................................................................................31
Clearing Faults in Electrical Components...................................................................31
Diagnosing Mechanical Faults ...................................................................................32
Chapter 6 – Maintenance.............................................................................................. 33
Periodic Maintenance; Verification Of Safety Systems............................................... 33
Maintenance Schedule............................................................................................... 33
Always........................................................................................................................33
Daily ...........................................................................................................................33
Weekly .......................................................................................................................34
Monthly....................................................................................................................... 34
Annually .....................................................................................................................35
Safety Checks, to be carried out monthly and after maintenance operations.............35
Air System Maintenance (some models, if equipped) ................................................36
Air/Oil Lubrication System (if equipped) ..................................................................... 36
Way Lube Maintenance.............................................................................................. 37
Adjustment ................................................................................................................. 37
On / Off Timer Settings............................................................................................... 37
Tool Turret Maintenance - Pragati..............................................................................38
Hydraulic System Maintenance.................................................................................. 38
Hydraulic Valves, Pressure Switches, and Gauges.................................................... 39
Hydraulic Chuck Proximity Switch Adjustment...........................................................41
Hydraulic Tailstock Speed Adjustment.......................................................................41
Chapter 7 – 8200 CNC Operation.................................................................................43
Milltronics 8200 CNC Front Panel .............................................................................. 43
Power ON...................................................................................................................43
Power OFF................................................................................................................. 43