Milwaukee M12 C4PLA - Specifications; Removing;Inserting the Battery

3
FUNCTIONAL DESCRIPTION
erutrepa resaL .1
nottub edoM .2
eguag leuF .3
4. Power save indicator
tekcarB toviP .6
tsujda orciM .7
dopirt dedaerhT .8
attachment
stengaM .9
10. Nail/Screw hole
6
3
4
5
2
1
7
8
10
9
SPECIFICATIONS
Cat. No. .............................................. M12 C4PLA
Volts........................................................... 12V DC
Battery Type .................................................M12™
Charger Type................................................M12™
Laser............................................................Class 2
Lines Max Power ................................. P
AVG
P:
Points Max Power................................ P
AVG
P:
Pulse Frequency..........................................10 KHz
Pulse Duration Normal Mode ................. T
P
V
Pulse Duration Power Save.................... T
P
V
:DYHOHQJWK.......................................... 510-530 nm
Lines Beam Divergence ................................. 1 rad
Points Beam Divergence .......................... 0.5 mrad
Storage Temp ....................................-20°C to 50°C
:RUNLQJ5DQJH ................................................38 m
5DQJHZLWK'HWHFWRU ....................................... 50 m
Accuracy ................................ ±3.18 mm over 10 m
Settle Time ......................................... < 3 Seconds
Tripod Mount ..................................1/4"-20, 5/8"-11
Ingress Protection............................................ IP54
'URS5DWLQJ .......................................................1 m
5HFRPPHQGHG Ambient
Leveling ............Auto ±°4 side to side, front to back
SYMBOLOGY
Operating Temperature ................. -20°C to 40°C
Volts
Direct Current
/$6(55$',ATION
DO NOT ST$5(,1TO BEAM
&/$66/$6(5352'8&7
Magnets
5HDGRSHUDWRUVPDQXDO
-
WARNING
Recharge only with the charger
anytime the tool is not in use.
WARNING
Always remove the battery pack
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
WARNING
To reduce the risk of injury or dam-
age, securely mount/attach the
laser before starting an operation. Injury/damage
may occur if the laser falls.
recommended for this tool. Others
may be hazardous.
Power Save
Fuel Gauge
To determine the amount of charge left in the battery,
turn the tool ON. :KHQ less than 7% of charge is
If the battery becomes too hot, the fuel gauge lights
ASSEMBLY
5HJXODWRU\&RPSOLDQFH0DUN
5&0 7KLV SURGXFW PHHWV
applicable regulatory
requirements.
Do not dispose of electric
tools together with household
waste material. Electric tools
and electronic equipment
that have reached the end of
their life must be collected
separately and returned to an
environmentally compatible
recycling facility.
8VH SRZHU VDYH PRGH WR H[WHQG WKH EDWWHU\
runtime. Power save mode is indicated by dimmed
laser beams and the Power Save Indicator pulsing.
Visual range is decreased in power save mode.
Power Save Indicator will change from pulsing to
solid Green when turned OFF. The tool will
automatically switch to power save mode if less
than 7% of battery charge remains.