Safety Precautions
12
For safe operation
Precautions in installation
CAUTION
Do not restart the power until 30 seconds after turn off
Do not put any matters on the cable
• If the device is restarted, do not turn on the
power until 30 seconds after turning off.
The device may be caused faulty function.
• Do not bend the power cable and the
communication cable, and do not placed any
matters. These cables may be broken and
heated, the power cable can cause fire or
electric shocks.
Do not climb on top of the machine Do not move your face in front of cut panel
• Please do not climb on top of the machine. It
may cause malfunction.
• Do not move your face and hands in front of
the cut panel while the unit is working.
The device can wind and touch your hairs or
hands.
Do not dress baggy suits and accessories The device is moved by our service engineer only
• Do not work with dressing baggy suits and any
accessories, and also tie any long hairs.
• The device is too sensitive equipment, so in
case if you require movement of the unit,
please contact to our service engineer.
CAUTION
A place exposed to direct sunlight A place that vibrates
• Do not install the device at a place where the
temperature of the cut panel surface exceeds
60?C. The cut panel can deform or break
down.
• The device will fail to give correct results if
installed in a place that vibrates.
A place in which temperature and humidity A place filled with dirt, dust or tobacco smoke
• Use the device under the following
environment.
Operating environment:
10 to 35 C
35 to 75 % (Rh)
• The plotter is a precision machine.
Do not use it in a place that is filled with dirt and
dust.
A plate that is not horizontal Near flammable materials
• If the plotter is not leveled, the plotter will fail to
give correct results. Also the tilted plotter can
break.
• When the blower is used fully open, the
exhaust port temperature becomes extremely
high. Do not place flammable materials near
the blower or in front of the exhaust port.
A place exposed to direct air blow from air conditioner., etc
• Cutting quality could be adversely affected.
To Next Page
Loading...
