Chapter 4 Helpful Tips
113
When [FRAME CUT] or [MARK CUT] is set to [ON]
• Once cutting is complete, the frame and overlap margin marks will be automatically cut.
• The display indicates the time remaining until frame and mark cutting is complete.
• The display switches to local mode once frame and mark cutting is complete. The sheet
can be replaced once the machine has switched to local mode. Do not replace the sheet
other than in local mode.
2
Set a new origin.
• Use the jog keys to move the carriage and set the origin.
• Replace the sheet if there is no cutting space.
3
Press the [REMOTE] key to select remote mode.
• The sheet will be fed corresponding to the maximum sheet length for the cutting data, then cutting
starts.
• If the sheet is not fed or if the sheet is too short, replace with a longer sheet in Step 2.
4
Repeat Steps 2 and 3.
• This continues until there is no longer any data exceeding the sheet width.
• Once complete, the tool conditions are displayed, and the machine returns to local mode.
4
To Next Page
Loading...
