MIMAKI CG-130AR - Feed Settings [FEED OPTION]

Chapter 4 Helpful Tips
120
• The [ENTER/HOLD] becomes available once sheet detection has ended.
• In local mode, hold down the [ENTER/HOLD] key for at least approximately 2.5 seconds.
Feed Settings [FEED OPTION]
Various feed related settings can be set.
Function name Outline Refer to
FEED OFFSET Feeds slightly more sheet when feeding the
sheet.
"FEED OFFSET
Setting"(P. 120)
FEED SPEED Reduces the feed speed to reduce the load
when using heavier sheets.
"FEED SPEED
Setting"(P. 120)
PRE FEED Sets automatic sheet feeding performed after
sheet detection.
"PRE FEED Setting"(P. 121)
FEED OFFSET Setting
This enables slightly more sheet to be fed when feeding the sheet such as with pre-feed.
This ensures sufficient slack as required when cutting (or printing).
If only a little amount of sheet remains on the roll, the roll sheet may be wound back on to the roll by the
vibration occurring during operation, leaving insufficient slack and preventing accurate cutting (or printing).
Feeding slightly more sheet minimizes such issues.
• The settings are retained even when the power is turned off.
• The [FEED OFFSET] setting is disabled when [OVER FEED] is set.
1
Press the [FUNCTION] key in local mode.
2
Use to select [SET UP], then press the [ENTER/HOLD] key.
3
Use to select [FEED OPTION], then press the [ENTER/HOLD] key twice.
4
Use to select the offset, then press the [ENTER/HOLD] key.
• Setting: 0 to 100cm
5
Press the [END] key several times to exit.
FEED SPEED Setting
The feed speed can be reduced to reduce the load when using heavier sheets.
1
Press the [FUNCTION] key in local mode.
2
Use to select [SET UP], then press the [ENTER/HOLD] key.
3
Use to select [FEED OPTION], then press the [ENTER/HOLD] key.
4
Use to select [FEED SPEED], then press the [ENTER/HOLD] key.
5
Use to select the feed speed, then press the [ENTER/HOLD] key.
• Setting: 1 to 30 cm/s