MIMAKI CG-60SL - Connecting the Cables; USB Cable Connection; Connecting the Power Cable

11
Connecting the cables
USB Cable Connection
When you want to connect the USB cable, you must observe the following notabilia.
Connecting USB driver
As for USB driver connection, refer to “USB Driver Installation Guide” in the supplied FineCut.
(1) Set the CD supplied with FineCut into the disk drive.
(2) Click [CD-ROM Contents] on the menu.
(3) Open [usb11_installguid(en).pdf] for the plotter used in [Mimaki USB1.1 Driver] folder.
Connector ports
This plotter uses the USB connector for connection
to the host computer.
Connecting the power cable
After connecting the interface cable, you must connect the power cable.
Connect the power cable with the plug outlet of the following power specifications.
•Voltage ：AC100 - 240V ± 10%
• Frequency ：50/60Hz
• Capacity : 145 VA or less
• Do not plug in or unplug any cable during data transferring.
• Follow the instructions on the LCD if the wizard is displayed when connecting the USB cable.
• Connect or disconnect the connectors
carefully. Applying undue force to a
connector may damage the connector.
Be sure to connect
the ground wire.
• Using without the
ground wire
causes the
damage of this
device and electric
shock that may be
very dangerous.
Regarding the use
of two polar plug
outlet, you must
connect the
auxiliary ground
adapter to the plug
of power cable.
• Earth the green wire (ground wire) of the
ground adapter. If you cannot, consult with
an electrician.