14
Installing a tool
Adjusting the protrusion of the cutter blade
Adjust the cutter blade according to the types of the cutters and the sheet for use.
After adjusting the protrusion of the cutter blade, set the cutting conditions and conduct test cutting to check
the cutting quality.
1
Take off the cutter holder and loosen
the Lock nut.
2
Turn the adjusting knob to adjust the
protruding amount of the cutter blade.
3
Tighten the lock nut so that the
adjusting knob will not turn.
• Take care not to protrude the blade too much. If the cutter is used with its blade excessively
protruded, the cutter can cut out the base paper, thus damaging the main unit.
Lock nut
Adjusting knob
To Next Page
Loading...
