Loading a sheet of media
26
5
Install the sheet support to the roll table
as shown in illustration.
6
Press the jog key or to select [ROLL].
• "Sheet detection" ( P.21)
• ：In the case the sheet is loaded from the rear
：In the case the sheet is loaded from the front
7
Start detecting the sheet.
8
Press the key to pull out the sheet
of the length you want to use.
• Before you use the roll sheet, previously pull out the sheet of the length you use to make
enough room. By feeding out the sheet, you can verify if there is any sheet misalignment or
not.
Sheet Support
A=654 B=459
CUT 1 2 0 0 5 0 0 . 3 0
Unit : mm
Displays the detected
size of the leaf sheet.
Displays the current
settings of tool conditions.
FEED
To Next Page
Loading...
