7
Work procedures
(2) Pass it through the rear hole of the bear-
ing BOX and the side hole of the power
supply rear cover (middle one of the three
holes).
(3) Fix it with the existing clamp inside the
power supply BOX.
(4) Connect it with CN14 and CN15 of the
big/ small feeding and taking-up PCB.
5. Perform wiring under the table.
(1) Loosen the hose clamp at the outlet of the
collecting tube and separate the hose
from the collecting tube.
(2) Attach the cuff to the attached hose and
fix it on the outlet of the collecting tube.
• Reuse the hose clamp.
To Next Page
Loading...
