8
(3) Fix the original hose with the banding
band as required. Put the hose newly
attached out of the machine from beneath
the bottom plate so that it may not contact
with the X bearing.
6. Perform wiring/ piping of the vacuum unit side.
(1) Connect the connector.
• Cable between the printer main body
and the vacuum is not included in this
vacuum option.
• For installation of the vacuum unit,
refer to the manuals below separately:
OPT-J0220 D500492
OPT-J0217/OPT-J0216 D500484
(2) Tighten the hose clamp and connect the
hose.
7. Change the setting of the inverter.
• Refer to P.9 “Changing vacuum control unit parameter”.
Put the hose newly attached here out of the
machine from beneath the bottom plate.
To Next Page
Loading...
