14
12. Recovery method of defective nozzle discharge
When this printer has not been used for an extended period of time, or depending on the environmental tem-
perature, the discharge at the nozzles could become unstable. In such a case, the following methods may be
taken to recover the status of the nozzles.
For symptoms 1 to 4 in P.13 “The examples of defective printing”
13. Supplies
1.Daily maintenance and care
Perform the cleaning of the parts described in this document.
2. Performing Head Cleaning (normal). Refer to Chapter 2 of
Operation Manual.
After having performed the care and maintenance stated in step 1, perform
the cleaning of the heads in accordance with the procedures stated in
Operation Manual.
Perform test printing and
check
(Chapter 2 of Operation Manual)
In the event nozzle missing etc. have not been improved
3. Performing Head Cleaning (hard). Refer to Chapter 2 of
Operation Manual.
If the nozzle missing does not disappear even after repeating the head
cleaning (normal) several times, reset the cleaning mode to "hard" and
perform the cleaning again.
Perform test printing and
check
(Chapter 2 of Operation Manual)
In the event nozzle missing etc. have not been improved
4. Perform the cleaning of the head nozzles. Refer to Chapter
4 of Operation Manual.
Perform the cleaning of the head nozzles. In this case, leaving time of the
cleaning liquid for maintenance shall be made [1 minute].
Perform test printing and
check
(Chapter 2 of Operation Manual)
In the event nozzle missing etc. have not been improved
5. Perform the cleaning of the head nozzles again. Refer to
Chapter 4 of Operation Manual
Reset the leaving time of the cleaning liquid for maintenance to [10
minutes], and perform the cleaning of the head nozzles again.
Perform test printing and
check
(Chapter 2 of Operation Manual)
• If the nozzle clogging does not recover after the above operations, contact your local distributor, our
sales office, or service center.
Product Name Product No. Product Name Product No.
Cleaning solution MS2/ES3/HS kit 200 SPC-0369 Kimwipe S-200 SPA-0207
Cleaning Stick for Head Surrounding (50 sticks) SPC-0527 Wiper cleaner SPA-0243
Male Connector Absorbent for MBIS SPC-0625 Square waste ink tank 2L SPA-0246
MBIS Eco case ASSY SPC-0626 Pinch roller SPA-0247
3 Inches Paper Tube 130 SPC-0825 Exhaust BOX SPA-0248
3 Inches Paper Tube 160 SPC-0826 Exhaust BOX filter SPA-0249
Media Cutter Blade SPA-0107 CP pad set 2 SPA-0257
Wiper kit 33S SPA-0134
To Next Page
Loading...
