Chapter 4 Maintenance
4-11
1
2
2
4
5
6
13
Fill up the cap with cleaning solution for
maintenance．
• Suck maintenance solution into a dropper and fill
up the cap with it. Fill up the cap with
maintenance solution on the verge of overflow
from the cap.
14
Close the front cover and press the
key.
• After its initial operation, the machine returns to
step2.
Cleaning the Ink Head
and the Area around It
Because the ink head employs a very precise
mechanism, due care needs to be taken when it is
cleaned.
Using a clean stick, etc., rub off gelatinous ink or dust that
may stick to the lower part of the slider and the area
around the ink head.In doing so, never rub the nozzles of
the head.
1
Press the
(MENU)
key in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press the key twice.
• “CARRIAGE OUT” will be selected.
3
Press , and press the key.
• “HEAD MAINTENANCE” will be selected and the
carriage will move to the left end of this machine.
4
Open the maintenance cover.
Tools required for cleaning
• Clean stick (SPC-0527) • Gloves
• Safety glasses
• Be sure to wear the attached safety glasses and
gloves when cleaning the area around the ink
head.Otherwise, you may get ink in your eyes.
• The ink contains organic solvent.If you get the ink
on your skin or in your eyes, wash it away with
plenty of water immediately.
To Next Page
Loading...
