MIMAKI SWJ-320 S2 - Ink Bottle Replacement and Charging; Replace Ink Bottle Procedure

© 2013 MIMAKI ENGINEERING CO.,LTD. 2.3.4 P.2
2.3.4 Central IO PCB assy.
R.1.1
1
2
3
4
5
6
7
8
 Test point
 Fuse Specification
 LED light on
Parts No. Signal Remarks
TP1-4 GND
Parts No., Rate Using Voltage Remark
F1 7A 37V
F2 3A 37V Spare
F3 3A 37V Spare
F5 3A 37V
Parts No. Check points Condition for lighting
D1 37V, CN1, CN3, F1 check HuseF1 is normal and 37V current from CN3 is on.
D2 37V, CN5, F2 check HuseF2 is normal and 37V current from CN3 is on.
D3 37V, CN6, F3 check HuseF3 is normal and 37V current from CN3 is on.
D4 3.3V, FPGA It is light on faintly when FPGA is completed to write down.
D11 5V, CN9 sensor check Not used. Not light on.
D12 5V, CN9 sensor check Not used. Not light on.
D13 5V, CN9 sensor check Wiper sensor; light on when sensor is on, light off when sensor is off.
D14 5V, Keyboard check Not used. Not light on.
D15 5V, CN9 sensor check Not used. Not light on.
D21 5V, CN9 sensor check
Y origin sensor; light on darkly when sensor is on, light on brightly when
sensor is off.
D22 5V, CN9 sensor check Not used.It is always light on darkly。
D23 5V, CN9 sensor check
Feeding slack sensor; light on darkly when sensor is on, light on brightly
when sensor is off.
D24 5V, CN9 sensor check
X origin sensor; light on darkly when sensor is on, light on brightly when
sensor is off.
D29 37V, CN17, F5 check HuseF5 is normal and current from CN3 is on.
MAINTENANCE MANUAL > Electrical Parts > Circuit Board Specifications > Central IO PCB assy.
Model SWJ-320S Issued
2012.07.19
Revised 2013.03.08 F/W ver. Remark
1.1
Rev.