MIMAKI SWJ-320 S2 - Setting Roll Media - Steps 7-8

© 2013 MIMAKI ENGINEERING CO.,LTD. 3.1.3 P.1
1
2
3
4
5
6
7
8
R.1.0
MAINTENANCE MANUAL > Workflow > Ink Related Parts > Replacement of the Ink Supply Pump
Model SWJ-320S Issued
2012.07.19
Revised F/W ver. Remark
1.0
Rev.
3.1.3 Replacement of the Ink Supply Pump
 List of replacement procedures
Item Work operation Description Ref.
Ink discharge
1.

Ink discharging of ink route Discharging the ink of ink route by executing the [#INK
PURGE] (Feed pump ON), in the condition that the ink tube
is disconnected from the ink bottle.
4.2.14
2. 
Power OFF Turning the main power OFF.
* Be sure to turn the main power OFF since the power
comes ON due to the sleep control if turned to OFF by
the power SW on the panel.
---
Ink Supply Pump
3. 
Ink Supply Pump replacement
6.2.3
Ink charging
4. 
Power ON Turning the power ON to start the machine.
---
5.

Head ink charging Executing the [#INK PURGE] (Feed pump ON) to charge
the ink to the head.
4.2.14
6. 
Test printing Checking the nozzle condition.
ink pump
filter
Be sure to wear protective glasses and working gloves during the operation.
Ink may get into your eyes depending on the working condition, or hand skin may get rough if you touch
the ink.