MIMAKI SWJ-320 S2 - Page 135

© 2013 MIMAKI ENGINEERING CO.,LTD. 6.2.3 P.1
R.1.1
1
2
3
4
5
6
7
8
6.2.3 Liquid supply pump
 Work procedures
1. Open the cover LRU, and lay waste around the pump.
2. Remove the connector of the pump motor.
3. Disconnect the tubes from the pump.
4. Remove the ink pump assy. from the holder.
5. Reverse the disassembly procedure for reassembly.
Proceed with the work after well confirmed the following processes in advance.
 3.1.3 Replacement of the Ink Supply Pump
Tube
Holder
Connector
Take care not to pollute the surroundings with
waste ink or washing liquid.
to the sub-tank
to the ink bottle
Be careful not to get wrong joint, when you con-
nect the tubes to the pump. (Refer to left figure.)
IN: to the Ink bottle
OUT: to the sub-tank (main body)
MAINTENANCE MANUAL > Disassembly and Reassembly > Ink-related Parts > Liquid supply pump
Model SWJ-320S Issued 2012.07.19 Revised 2013.02.15 F/W ver Remark
1.1
Rev.