MIMAKI SWJ-320 S2 - Page 47

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.1.1 P.2
4.1.1 For Head adjustment jig
R.1.0
1
2
3
4
5
6
7
8
2. (Attach the head adjustment jig to the head.)
3. Turn the forward/backward position adjustment screw and tilt
adjustment screw clockwise and push out the adjustment bars.
Separate this section
and the jig 2 mm
Tighten the screws
Near side
Push out the forward/backward position adjustment bar
Push out the tilt adjustment bar
MAINTENANCE MANUAL > Adjustment > Operation Matrix > For Head adjustment jig
Model SWJ-320S Issued 2012.07.19 Revised F/W ver Remark
1.0
Rev.