MIMAKI SWJ-320 S2 - Page 54

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.2 P.2
4.2.2 [HEAD ADJUST] Carriage base tilting
R.1.0
1
2
3
4
5
6
7
8
 Adjustment procedure
1. Select [#ADJUST / HEAD ADJUST].
2. Select [AVERAGING ADJ.].
3. Print the adjustment pattern.
4. Check the tilting of all heads, and determine the head unit most
slanting to the right.
Adjust the tilting of carriage base if the tilting of the head most
slanting to the right is out of the acceptable range.
Specified value: 0 ± 10 μm
#ADJUST
HEADADJUST [ENT]
#HEADADJUST
AVERAGINGADJ.[ENT]
#AVERAGINGADJ.
PRINT [ENT]
#AVERAGINGADJ.
**PRINTING**
Within 10 μm
Patern of Slant adjust (AVERAGING ADJ.)
The distance between the center of 2 broken lines and the
line center should be within 10 μm.
Head condi-
tion
Figure when viewed
with a scope
Adjustment
No adjustment
required.
If out of accept-
able range,
adjust the tilt-
ing of Carriage
base.
If out of accept-
able range,
adjust the tilt-
ing of Head
unit.
Not tilted
Tilted to
the right
Tilted to
the left
Be sure to verify multiple straight line positions at
the top, center, and bottom of the pattern.
If the ink discharge trajectory is skewed, the tilt
cannot be adjusted properly.
MAINTENANCE MANUAL > Adjustment > Adjustment Items > [HEAD ADJUST] Carriage base tilting
Model SWJ-320S Issued 2012.07.19 Revised F/W ver 2.20 Remark
1.0
Rev.