MIMAKI SWJ-320 S2 - List of Functions Overview

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.6 P.2
4.2.6 [HEAD ADJUST] STAGGER ADJUST
R.1.0
1
2
3
4
5
6
7
8
 Head stagger check procedure
1. Select [#ADJUST] -> [HEAD ADJUST] -> [STAGGER
ADJUST] from the operation menu.
2. Press the [ENTER] key to print the pattern.
[ENTER]: Starts printing the pattern.
[FUNCTION]: Cap OFF
[]/[]/[]/[]: enters into the jog mode (moves the
origin of the pattern)
3. Make to take off the cap on the head.
4. Check if the head is staggering.
Using a scope, check that the Headline1 and Headline2 patterns
overlap by 4-dots width. Check the same thing for the
Headline2 and Headline3 patterns. If the overlapped width is
improper, go to Head stagger adjustment procedure.
Tolerable range: 0 ± 10 μm
<LOCAL>
width:1000mm
FUNCTION
#ADJUST [ENT]
#ADJUST
HEAD ADJUST [ENT]
[FUNCTION]
#HEAD ADJUST
STAGGER ADJUST [ENT]
#STAGGER ADJUST
PRINT START [ENT]
Do not perform this adjustment with the carriage
located on the Station Assy (cap). Make sure to take
cap off.
1
2
3
4
<Scope image>
Dot of Headline1
Overlapped
by 4-dots
Dot of Headline2
Headline
Headline
Headline
MAINTENANCE MANUAL > Adjustment > Adjustment Items > [HEAD ADJUST] STAGGER ADJUST
Model
SWJ-320S
Issued
2013.03.08
Revised F/W ver 2.20 Remark
1.0
Rev.