© 2011 MIMAKI ENGINEERING CO.,LTD. 6.2.9 P.2
6.2.9 Changing Joint
1
2
3
4
5
6
7
8
Work procedures
1. Execute [#ADJUST] — [HEAD WASH] to discharge the ink.
(Refer to 4.2.11)
2. Remove the cartridge cover.
3. Loosen the joint screws and remove the tube and O-rings.
4. Put on the rubber plugs on the coupler.
5. Tighten the joint screws.
Leave a space of around 0.5 mm between the coupler and screw.
Be sure to wear protective glasses and working gloves during the operation.
Ink may get into your eyes depending on the working condition, or hand skin may get rough if you touch
the ink.
Make sure that O-ring is not remaining in the joint
screws.
When clamping the joint screws, do not clamp them
too much.
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Ink-related Parts > Changing Joint
Model
TS34-1800A
Issued
2011.10.17
Revised F/W ver
1.20
Remark
1.0
To Next Page
Loading...
