© 2011 MIMAKI ENGINEERING CO.,LTD. 5.1.13 P.1
1
2
3
4
5
6
7
8
R.1.0
5.1.13 SENSOR TEST
Purpose
To check if the each sensor of the instruments machine functions normally.
Function
Various sensors are tested. Before starting the test, the servomotor and stepping motor are turned off. After finishing
the test, initial movement of original position detection is executed.
List of sensor test
No. Item Description LCD display
1 SET LEVER State display of clamp lever sensor ON/OFF
2 R.PAPER State display of rear paper sensor (L/R) ON/OFF
3 Y-ORIGIN State display of Y origin sensor ON/OFF
4 WIPER State display of wiper sensor ON/OFF
5 Front cover State display of the cover sensor (Front and maintenance LR)
6 HEAD HEIGHT State display of head height sensor ON/OFF
7 Main PCB ID Judgment of main PCB 800 and more
8 Head Voltage(1) Judgment of the voltage of Head 1
If it is 800 and below, the voltage may drop or fuse may be melt down due to
the head defect.
800 and more
9 Head Voltage(2) Judgment of the voltage of Head 2
If it is 800 and below, the voltage may drop or fuse may be melt down due to
the head defect.
800 and more
SET LEVER
(Clamp Sensor)
Y- OR IG IN
(Y-origin Sensor)
HEAD HEIGHT
(Head Height Sensor)
WIPER
(Wiper Origin Sensor)
R.PAPER
(Paper SENSOR)
Front cover
(Cover sensor)
MAINTENANCE MANUAL > Test Items > Test Function > SENSOR TEST
Model
TS34-1800A
Issued
2011.10.17
Revised F/W ver
1.20
Remark
1.0
To Next Page
Loading...
