© 2011 MIMAKI ENGINEERING CO.,LTD. 6.3.3 P.2
6.3.3 Y Drive Pulley
1
2
3
4
5
6
7
8
3. Manually move the print head carriage on the platen and
remove the D-BKT cover.
4. Loosen the screws from the Y-SP plate on the left side of the
main body, and release the tension of the Y drive belt.
5. Remove the screw from the top of the Y drive pulley.
6. Slide out the connection point of the Y drive belt, and remove
either the left or right belt holder from the belt holder.
Do not remove the screws.
Belt Holder
Belt Holder
Do not remove the Y drive belt from the slider.
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Drive System > Y Drive Pulley
Model
TS34-1800A
Issued
2011.10.17
Revised F/W ver
1.20
Remark
1.0
D-BKT Cover
Y Drive Belt33
Y-SP Plate
Loosen
To Next Page
Loading...
