MIMAKI TS34-1800A - Page 198

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.4.2 P.2
6.4.2 Main PCB Assy
1
2
3
4
5
6
7
8
4. Draw the regenerative resistance PCB assy out of the main
PCB assy.
5. Open the HDC PCB BKT.
6. Remove the screws and then remove the main PCB assy.
7. Remove the following from the removed main PCB assy.
• PRAM PCB Assy
• Connector recognizing that no heater exists
8. Reverse the disassembly procedure for reassembly.
Regenerative Resistance
PCB Assy
Main PCB Assy
Screw
HDC PCB BKT
PRAM PCB Assy
Connector recognizing
that no heater exists
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Electrical Parts > Main PCB Assy
Model TS34-1800A Issued 2011.10.17 Revised F/W ver 1.20 Remark
1.0
Rev.