4
3. Periodically care (Once a week)
Users are advised to perform the maintenance works described below once a week so that the printer will
keep its high performance and accuracy over an extended period of its life.
(1) Exterior (“Cleaning the Exterior Surfaces” “Cleaning the table” Chapter 4, Operation
Manual)
Depending on the using environment, the dusts or sand powder could stick to the exterior of the main unit. To
avoid the entry of the dusts into the moving part of the head, wipe them off with soft cloth dipped into water
and squeezed tightly.
(2) Waste ink tank (“If a Waste Ink Tank Confirmation Message Appears” Chapter 4 of
the Operation Manual)
Check whether the waste ink tank is full or not. Take care so
that the waste ink never overflows the tank.
(3) Clean the mist filter 2. (“Cleaning the mist filter” Chapter 4 of the Operation Manual)
If the stain is strong, please replace the filter referring to the
Operation Manual Chapter 4 “Replacing the mist filter”.
To Next Page
Loading...
