Mimosa Backhaul Help Content
Mimosa Backhaul Reset Process
Copyright © 2014 Mimosa Page 4
Reset B5/B5c and B11
Product Applicability: B5/B5c, B11
This process is to restore the device to the factory state when the device is physically available. It replaces
This process is to restore the device to the factory state when the device is physically available. It replaces
a physical reset button and allows recovery without the need to climb a tower.
a physical reset button and allows recovery without the need to climb a tower.
Follow these steps to reset the radio:
Unplug both Ethernet cables from the POE. Leave unplugged for about 3 seconds.1.
Plug in only the data + power cable to the radio. Do not plug in the LAN cable.2.
Immediately connect to the "mimosaR###" SSID (where ### = the last three digits of the serial number)3.
with a PC or mobile device. The SSID and total recovery window expires after 5 minutes.
With a web browser, navigate to 192.168.26.14.
Enter the device serial number located on back of device and click enter.5.
Click the reset button to factory reset the device. This action will remove all configuration settings and6.
passwords.
The radio will then reboot for about 90 seconds.7.
After factory reset, access the device with the default IP address, then follow the device unlock process again before
reuse.
It is also good practice to create a configuration backup such that it can be restored in the case of lost passwords.
To Next Page
Loading...
Need help?
General
