Mimosa Backhaul B5c

To Next Page

To Previous Page

Mimosa Backhaul Help Content

Mimosa Backhaul B5-Lite

March 7, 2016: Firmware version 1.3.0 was removed because of a performance impacting bug that was

just discovered. B5, B5c, and B5-Lite are affected. We intend to release version 1.3.1 to correct the bug

shortly. In the mean time, please continue to use firmware version 1.2.3 or 1.2.4.

IMPORTANT Firmware images are product specific. Confirm firmware image name matches the product

before upgrading. This firmware must be installed on both sides of the link to properly associate. You must

upgrade the remote side of the link first, and then the local side.

New Features

Support for B11

Mimosa's latest licensed backhaul product supporting 10-11 GHz and fiber connectivity. (B11)

Low Latency Auto Mode

Redesigned MAC with elastic transmit slots to minimize latency and maximize throughput for traditional links (not

GPS synchronized). The default configuration is 4ms, and this value cannot be changed. This is the only mode

available for B5-Lite.

Dual Link Interference Avoidance

Dynamically routes traffic to channel with least PER to improve noise immunity and prevent packet loss. (B5, B5c,

B11)

Auto Power Optimization

Automatically adjusts Tx power to avoid compression and improve (minimize) EVM when SNR allows. (B5, B5c, B11)

Extended Frequency Range to 6.2 GHz

Channel selections from 6000 to 6200 MHz where regulations allow. (B5c, B5-Lite)

Remote Antenna Gain Input

Set both local and remote antenna gain on AP to improve signal target and Aiming Mode accuracy. (B5c, B11)

GPS Interference Mitigation

Maintains link stability at all times with an internal timer in varying GPS conditions. (B5, B5c, B11)

User Interface

Enabled Site Survey for AP mode.

●

Added "Off" selection to LED Brightness options.

●

Increased detail for GPS and unlock event messages.

●

Added null VLAN ID validation check.

●

Mimosa Backhaul B5c - Page 226