Mimosa Backhaul Help Content
Mimosa Backhaul B11
Copyright © 2014 Mimosa Page 226
available for B5-Lite.
Dual Link Interference Avoidance
Dynamically routes traffic to channel with least PER to improve noise immunity and prevent packet loss. (B5, B5c,
B11)
Auto Power Optimization
Automatically adjusts Tx power to avoid compression and improve (minimize) EVM when SNR allows. (B5, B5c, B11)
Extended Frequency Range to 6.2 GHz
Channel selections from 6000 to 6200 MHz where regulations allow. (B5c, B5-Lite)
Remote Antenna Gain Input
Set both local and remote antenna gain on AP to improve signal target and Aiming Mode accuracy. (B5c, B11)
GPS Interference Mitigation
Maintains link stability at all times with an internal timer in varying GPS conditions. (B5, B5c, B11)
User Interface
Enabled Site Survey for AP mode.
●
Added "Off" selection to LED Brightness options.
●
Increased detail for GPS and unlock event messages.
●
Added null VLAN ID validation check.
●
SNMP
Added auto Tx and Rx Channel Widths to Streams Table to match GUI.
●
Added Primary and Secondary DNS IP addresses.
●
Added RPS status.
●
Compliance
Updated regulatory database: China, Finland, France, Malaysia, Netherlands, New Zealand, Thailand, UK,
●
Vietnam.
Resolved Issues
Platform Stability
Fixed SNMP memory leak.
●
Fixed rare conditions causing radio reboots.
●
Radio (PHY and MAC) Improvements
TPC per chain variance limit raised to better accommodate wide power differences between channels.
●
Resolved conditions causing Spectrum Analyzer to improperly categorize the remote radio as noise.
●
To Next Page
Loading...
Need help?
General
