Mimosa Backhaul Help Content
Mimosa Backhaul Performance
Copyright © 2014 Mimosa Page 34
Turning Off Auto Everything
Auto Everything can be turned off by selecting "Off (Manual)" in the drop-down box. If turned off, Auto
Everything will stop monitoring channel health and will no longer change channels. However, the AE process will
continue performing channel analysis in the background and maintaining a list of best channels for when AE is re-
enabled. Recommendations from this channel analysis are available on the Channel & Power page for manual
selection.
Auto Everything and Excluded Channels
Auto Everything can be prevented from using specific frequency range(s) by adding them to the exclusion list on the
AP (Wireless > Channel & Power > Exclusions & Restrictions), and then saving. The station will inherit the same
exclusions from the AP during association. This will restart the current background channel analysis process and
exclude both the newly added channels and any channels on the existing exclusion list. Auto Everything will also
change the current channels if the new exclusion channels make them invalid. Similarly, removing channels from
the exclusion list will restart the background channel analysis to make use of newly available channels.
To Next Page
Loading...
Need help?
General
