18
3-2-3 Example
Example 1: One handheld unit and one cradle
The following takes channel No.5 for instance.
Step 1): Set Handheld unit RF channel No. of the handheld unit to 5.
Step 3): Scan the following barcode to bind the handheld unit with the cradle.
Firmly position the handheld unit onto the cradle. Within 10 seconds, two beeps will be emitted to
signal that the cradle has been paired to the handheld unit, and the blue LED on the handheld unit will
go off. If three beeps are emitted, it indicates unsuccessful pairing between the cradle and the
handheld unit; then repeat step 3).
Test barcode:
To Next Page
Loading...
