Mindray BA-88A Service Manual

5 Service and Maintenance
5-
7
5.2.4 Upgrading Procedures for Software on CPU Extension
Board
1
Please make sure the FPGA software or lower computer software has been copied to
relevant directories on U disk.
If not, execute the CPU board software upgrading again. But only FPGA software or
lower computer software is needed to be copied the U disk.

Mindray BA-88A Specifications

General

Light source	Halogen lamp
Display	7 inch touch screen
Printer	Thermal printer
Interface	RS232
Wavelengths	340, 405, 546, 578, 630nm
Carry-over	< 1%
Power Supply	AC 100~240V, 50/60Hz
Operating Temperature	15-30°C