3 - 6 Defibrillator/Monitor Operator’s Manual
■ In the AED mode
Press the [High Contrast] soft key to enable the high contrast display. To disable the high contrast display,
press the [Full Color] soft key.
Once [High Contrast] is selected, the high contract display remains when you change the operating mode.
However, the setting will not be saved if the equipment is turned off.
3.3.5 Adjusting Waveform Position
1. Press the Main Menu button on the front panel, and then select [Others >>]→ [Waves >>].
2. Set [Wave 2] and [Wave 3]. [Wave 1] is always ECG1, which is unchangeable.
You can also change waveform position by selecting [Waveform Setup] from the Configuration Main menu.
3.4 Analog Output
The equipment is configured with a multifunction connector for ECG analog output.
To Next Page
Loading...
