P/N: 046-003757-00 Rev A
Quick Reference Guide
2
Discharge A Patient
The Discharge function clears all patient information and restores default
(preconfigured) settings.
To Discharge a patient from the DPM 6 or DPM 7 bedside monitor:
a. Access Patient Setup menu using Patient Setup
(quick key) or
Main Menu
(quick key)
b. Select Discharge Patient
c. Select OK to confirm
Note: After the patient is discharged, default (preconfigured) settings are
restored, and the monitor is placed in Standby.
Panorama® Central Station Interface: Discharging a patient from the DPM 6
or DPM 7 bedside monitor will automatically discharge the patient from the
Panorama® Central Station, WorkStation, and ViewStation. Discharging the
patient on the Panorama® Central Station will discharge the patient from the
WorkStation, ViewStation, and DPM 6 or DPM 7 bedside monitor (optional).
STANDBY
Enter Standby
The Standby function allows the clinician to suspend monitoring on a patient.
While in standby, the patient is not monitored; however, all data and settings
are preserved.
To place a patient into Standby on the DPM 6 or DPM 7 bedside monitor:
a. Select the STANDBY
(quick key)
b. Select Yes to confirm
Resume Monitoring
To remove a patient from Standby and resume monitoring on the DPM 6 or
DPM 7 bedside monitor:
a. Select any key on the DPM 6 or DPM 7 bedside monitor
Panorama® Central Station Interface: Placing a patient in standby at the
DPM 6 or DPM 7 bedside monitor will automatically place the Panorama®
Central Station, WorkStation, and ViewStation in standby. Selecting Bedside
and Panorama® Standby on the Panorama® Central Station or WorkStation
To Next Page
Loading...
Need help?
General
