Mindray MR6401 - Product Specifications

6
MR6401 CPR Sensor Operator’s Manual
Problem Corrective Actions
The sensor cable is not securely inserted,
or it easily falls off.
Plug the sensor cable into the connector and fasten it
with the cable retainer.
Product Specifications
WARNING
●
The CPR sensor may not meet the performance specifications if stored or used outside the
specified temperature and humidity ranges.
Safety
Classifications
(according to
IEC 60601-1)
Degree of protection against
electrical shock
Type CF defibrillation proof
Type of protection against
electrical shock

Used alone: Class II, equipment energized from an
internal electrical power source.

Used together with the defibrillator or monitor:
Class II, equipment energized from a specific or
internal electrical power source.
Degree of protection against
harmful ingress of water
IP55
Drop height 1.5 m
Degree of protection against
hazards of explosion
The equipment is not suitable for use in the presence
of a flammable anesthetic mixture with air with oxygen
or nitrous oxide.
Mode of operation Continuous
Evironmental
Specifications
Operating conditions Storage conditions
Temperature 0°C to 50°C -30°C to 70°C
Relative humidity 10% to 95%,
non-condensing
10% to 95%,
non-condensing
Barometric 57.0kPa to 106.2kPa 57.0kPa to 106.2kPa
Power
Specifications
Input voltage
5 to 12V
Power consumption Not applicable
Battery
Specifications
(optional)
Capacity ≥230 mAh
Voltage 3.8 V
Run time

At least 3 hours when the CPR sensor works
continuously at a temperature of 25°C±5°C with a
fully-charged battery.

At least 30 days when the CPR sensor is in the
sleeping status.

At least 1 hour after the battery indicator is in red
light.
Charge time At most 1.5 hours to a full charge when a depleted
battery is charged at a temperature of 25°C±5°C.