Mindray Resona I9 User Manual

Patient Data Management 10-11
10.4.1 Viewing Patient Information
Data Source
Select the data source of patient data, the system patient database is default.
Patient list
Display patient information, exam mode, number of images and cines, exam state, backed up or
not.
New Exam
After you select a patient data or exam in the iStation screen, click the [New Exam] to enter the
Patient Info screen, where you can select the exam mode and click [Save] to begin a new exam.
Select All/Deselect All
Click [Select All] to select all the patient data listed. Then the button changes into [Deselect All], you
can cancel all the selections by clicking [Deselect All].
10.4.2 Searching a Patient
1. Select the data source.
Click [Data Source] to select the data source of patient data, the system patient database is
default.
2. Set search conditions in the "Item" drop-down list.
3. Enter the key word. The matching patient information is displayed in the patient list.
4. When you select a patient in the patient list, the images of this patient will be displayed at the
bottom of the screen.
10.4.3 Patient Data View & Management
Select the desired patient information in the list. The following menu pops up:

Mindray Resona I9 Specifications

General

Power Supply	100-240V AC, 50/60Hz
Operating Temperature	10°C to 40°C
System Type	Ultrasound System
Touchscreen	Yes
Imaging Modes	Color Doppler, Power Doppler
Advanced Imaging	V Flow
Connectivity	DICOM, USB, HDMI, Ethernet
Probes	Convex, Linear, Phased Array, Volume
Portability	Cart-based
Storage Temperature	-20°C to 55°C
Humidity Range	30% to 80% (non-condensing)
Display	23.8-inch high-resolution LED monitor
Transducer Ports	4