Maintenance and Cleaning
6-2
6.2 General Cleaning
Warning
Be sure to shut down the system and disconnect all power cords from the
outlet before cleaning the equipment or accessories.
The VS-800 Vital Signs Monitor should be free from dust.
The exterior surface and LCD should be cleaned with non-corrosive cleaning solutions, such
as the diluted soap water and water.
• Warning
To avoid damages to the VS-800 Vital Signs Monitor:
ALWAYS dilute the solutions according to the manufacturer’s suggestions;
ALWAYS wipe off all the excess cleaning solution with a dry cloth after cleaning;
NEVER submerge the equipment into water or any cleaning solution, or pour or
spray water or any cleaning solution on the equipment;
NEVER permit fluids run into the casing, switches, connectors, or any ventilation
openings in the equipment;
NEVER use abrasive or erosive cleaners of any kind as well as cleaners containing
acetone.
6.3 Disinfection
Disinfection may cause damage to the equipment; therefore, only the disinfection that is
considered necessary as per the hospital’s service plan is recommended. Before disinfecting
the equipment, clean it first.
For the disinfections of SpO
2
sensors, NIBP cuffs and TEMP probes, refer to relevant chapters
in VS-800 Operation Manual.
To Next Page
Loading...
