14
YES
YES
NO
NO
5
Connect the connector surely.
Execute the repair of the input cable
Connection of the
connector is wrong
Cut−off or shorten of the
wire in the input cable
Inform us about the contents of
failure and situation at site in details.
Connection is
defective of the input
cable.
YES
YES
YES
NO
NO
NO
The position match
of the rotor and stator cannot
be done.
6
Execute the repair or exchange the
torque transducer
Set the correct position refering to the
instruction manual of torque transducer
Cut−off and shorten
of the input cable wire
5
YES
NO
Remove the LED protection cover
Forget to remove LED
protect cover of torque transducer
(rotor section)
Inform us about the contents of
failure and situation at site in details.
To Next Page
Loading...