17
3
Selection of writing or reading out(R/W)
Select writing or reading out by the command order.
Writing the data set in general−purpose data area (RWw000C−RWw000D) by command NO.
(RWw000E) is ordered for writing.
Reading out the data set in general−purpose data area (RWw000C−RWw000D) by command
NO. (RWw000E) is ordered for reading out.
ON ：Reading out
OFF ：Writing
4
Operation mode changeover request (Request 3)
Requests the writing of the data set in operation mode (RWw000F).
ON ：In the request of writing request.
OFF ：After confirming “Operation mode changeover response (Response 3)” of remote
input.
5
ZERO
Execute the zero set.
ON ：In requesting the execution of zero set.
OFF ：Normal
6
A/Z ON
Start an automatic zero.
ON ：In the request of starting the automatic zero.
OFF ：Normal
7
A/Z OFF
Clear the automatic zero.
ON ：In the request of A/Z clear.
OFF ：Normal
8
Initial proseccing complete flag
Send the initial proseccing complete flag when it will recive [RX078] command,
ON ：Data clear request
OFF ：Normal
9
Initial data setting request flag
Request the initialization of the instrument.
ON ：In the request of default setting.
OFF ：Normal
10
Error re−set requesting flag
When the error generation is notified with error condition command [RX007A], request the
release of the error.
ON ：In the request of clear
OFF ：Normal
11
Indicate value NET weight value/GROSS weight value comunand(2 stations, 1station)
Select the indication valiue [NET] or [GROSS] in remote resistor area when the station
occupies 1 or 2,
ON ：NET weight value (Same value of remote resistor at the occupies 4 stations)
OFF ：GROSS weight value (Same value of remote resistor at the occupies 4 stations)
To Next Page
