64
SOUNDS
Start Up Sequence
When the detector is turned on, there is
a short three note tune during its start up
sequence.
Positive Acknowledgement
The detector emits a short beep for every
accepted key press.
Negative Acknowledgement
The detector emits a low double beep to
indicate an invalid keypress.
Patterns Erased / Factory Preset
A six note tune will announce when these
settings are complete.
Error
A six note tune will sound to indicate a
detector error (Error Messages, p. 66).
Overload
If the coil is passed across a large shallow
target, the detector will give a repeating
buzzing sound. This indicates that the target
signal is too strong for the detector to
interpret.
Low Battery Signal
When the battery power becomes low,
there will be a short announcement tune
(descending tones) every 60 seconds.
To Next Page
Loading...
