Welcome-MING DA-15.3262 5:23:28
OFFLINE
25 00
25/0 0/0
X:0 Y:0 Z:0 E:0
SD: No SD file to print!
SD
PreheatPLA
Back
PreheatABS
+1
-1
+1
-1
+10
-10
+10
-10
ClearBed ClearHead
200
80
Rotate control knob to
temperature option, press control knob.
Select PreheatPLA,
change the nozzle temperature to 200°C,
select Back to return main interface.
10
Welcome-MING DA-15.3262 5:23:28
OFFLINE
200 00
200/0 0/0
X:0 Y:0 Z:0 E:0
SD: No SD file to print!
SD
12
Once temperature is up to
200 °C, press retainer, and
then insert material to nozzle.
13
Once melting wire flows out
from nozzle, it means loading
material is successful, then insert material tube.
11
Calibration4
Only need to calibrate for the first time.
Notes:
Select
1
Select
2
Select NextStep for 5 times, and review
the gap between nozzle with hot bed,
it’s recommended by ~0.1 mm
(It’s proximate to the thickness of paper).
3
Adjust Platform
LastStep NextStep
Back
Retreat
Feed
Preheat...
To Next Page
Loading...
