65
HOLD.
Press this button to turn HOLD mode on and off. When the hold mode
is activated, the meter beeps, freezes the display, and displays the
HOLD indicator on the LCD. Hold mode freezes the display for later
view.
Auto Hold.
To activate auto hold mode, press the HOLD button twice until A– and
HOLD indicators appear on the LCD. This mode is not available for
capacitance measurement.
In this mode the display automatically freezes and the meter beeps
when the measurement reading is stabilized. The displayed value will
be updated when a new measurement value is stabilized.
This mode is very useful when it is impossible for you to press the
HOLD button or see the meter display while probing and taking
measurements.
MEM.
Use the memory mode to store and recall measurement values.
Press the MEM button momentarily in order to activate the memory
mode. The display shows four menu selections: Store, Recall, Clear
and EXIT.
Store. Select Store to store the held value in the next available memory
location. The memory location number momentarily shows on the
secondary display. If no memory locations are available, shows
on the primary display for two seconds and nothing is stored, when you
must clear the memory locations using the Clear key in order to store
the held value.
Recall. Select Recall to review the stored value using the menu key.
The primary display shows the value stored in that location. Whenever
you press + or – menu key, the next or previous stored value will be
shown in the primary display and the secondary display momentarily
shows the corresponding memory location .
To Next Page
Loading...
