66
Clear . Select Clear to clear all the stored values. When you press
Clear key, the meter will ask you with the display of along
with the On Screen Menu Selections of AC (stands for ALL Clear),
Clear and EXIT. When you press the Clear (availiable only in Recall
option) key, the displayed value in the primary display is erased. When
you press the AC key, all the stored values are erased and the word
shows on the display. Press EXIT key to exit memory mode without
erasing the stored values.
EXIT. Select EXIT to exit memory mode. You can also exit memory
mode by pressing MEM button or turning the rotary knob position.
(Backlight) Button.
Press the MEM ( ) button until the backlight is turned on or off.
4.4 On Screen Menu Selection Keys.
Each setting of the rotary switch to a measurement function position
may activate one or more menu selection key settings on t he LCD.
If there is more than one measurement for a rotary switch setting, a
menu appears on the display. Press the corresponding menu selection
key to select the desired measurement .
4.5 Setup Mode
The Setup Mode allows you to customize default settings. To activate
the Setup Mode, press the menukey 4 while the display shows all
segments on at power on reset.
You can customize the following default settings in sequence during
the Setup cycle. The newly customized default values in any Setup
can be saved only when the entire Setup cycle is ended. The
meter displays at the end of the entire Setup cycle. The Setup
values are saved on EEPROM so they cannot be lost when the meter
is turned off.
To Next Page
Loading...
