Minipa ET-2907 - Pulse Width Measurement; Resistance Measurement (Ω)

75
Positive duty cycle : % duty = a/b x 100 (above trigger point)
Negative duty cycle : % duty = (1–a/b ) x 100 (below trigger point)
5.2.2 Pulse Width Measurement
The pulse width measurement function allows you to measure the
amount of time a signal is high or low within a given period. The measured
waveform must be periodic.
5.3 Resistance Measurement (
ΩΩ
ΩΩ
Ω )
Caution
To avoid damaging the meter or the equipment under test, remove all
power from the circuit and discharge all high-voltage capacitors before
measuring resistance.
The available resistance ranges are: 50.000Ω, 500.00Ω, 5.0000kΩ,
50.000kΩ, 500.00kΩ, 5.0000MΩ, and 50.000MΩ.
tnemerusaeMyekuneMsdaeLtcennoC
yramirP
yalpsiD
yradnoceS
yalpsiD
ecnatsiseR
)tluafed(
)noitceleson(
Ω
S
)ecnatcudnoC(