MINN KOTA RIPTIDE POWERDRIVE Installation Guide

NOTICE: To prevent seizing of the stainless steel hardware, do not use high-speed installation tools. Wetting the screws or applying an anti-seize may help prevent
seizing.
9
m. Replace the Right Sideplate.
n. Swing the Left Sideplate back into its correct position on the Base Extrusion.
10
o. Replace the four side plate screws using a #3 or #2 Phillips screwdriver. Two of these screws will be located on each side of the mount.
11

MINN KOTA RIPTIDE POWERDRIVE Specifications

General

Water Type	Saltwater
Speed Control	Variable
Digital Maximizer	Yes
i-Pilot Link	Optional
Speed Settings	Variable
Weight	Varies by model
Voltage	12V, 24V
Shaft Length	48", 54", 60"
Control Type	Foot Pedal, i-Pilot, or i-Pilot Link
Steering	Electric Steering
Mounting Location	Bow
Battery Requirement	12V or 24V Deep Cycle Marine Battery
Motor Type	Electric
Warranty	2 years
Thrust	55 lbs
i-Pilot	Available on select models