MINN KOTA Riptide Ulterra - Resetting Motor Position Functions; Stopping Stow Sequence for Park Position; Manual Park Position Adjustment

48 | minnkotamotors.com
©2019 Johnson Outdoors Marine Electronics, Inc.
ADvANCED TROUBLESHOOTING
2
3
b. Send a command to stow the motor via the remote
or Foot Pedal. Allow the Ulterra motor to steer the
lower unit, raise straight up, rotate the shaft and
motor assembly into the horizontal/stow position,
then you must STOP the stow sequence by pressing
the Stow/Deploy button before the Ulterra starts to
pull the lower unit on to the motor ramps.
c. At this point, turn the Ulterra OFF by pressing and
holding the Power button on the Indicator Panel
about three seconds until the green System Ready
LED turns off.
d. Wait about five seconds, then manually rotate
the motor lower unit into the Park Position by
grasping and turning either the lower unit or the
control box head. The motor should be positioned
so that it is laying horizontally at 90 degrees to the
mounting base with the prop to the left or right (per
your preference).
e. Turn the power back on at the control panel and
stow/deploy the motor to test and confirm that the
Park Position has been reset correctly. Repeat this
procedure, if necessary, to tweak the Park Position.
P
a
u
se
Deploy
TEMP 199 °F DPTH 9999 kmBRG 359°
12:53 PM
Motor Stowing
AUTOPILOT
SPOT-LOCK
MODE
CONSTANT
AUTOPILOT
SPOT-LOCK
MODE
CONSTANT
i-Pilot Remote
Foot Pedal
Stow/Deploy
ULTERRA
Status
Indicator
Power
Button
System Ready
Indicator
Park Position
Park Position
3c
3d 3d
i-Pilot Link Remote