134
135D
ATA-TRANSFER MODE
When the camera is properly connected to the com-
puter, a drive icon, or volume, will appear. When
using Windows XP or Mac OS X, a window will open
requesting instructions on what to do with the image
data; follow the directions in the window. If the com-
puter does not recognize the camera, disconnect the
camera and restart the computer. Repeat the connec-
tion procedure above.
CHANGING THE MEMORY CARD (DATA-TRANSFER MODE)
Care should be taken when changing memory cards while the camera is
attached to the computer. Data could be lost or damaged if the camera is not
properly disconnected. Always confirm the access lamp is out before remov-
ing the memory card.
WINDOWS 98 / 98 SECOND EDITION
1. Turn off the camera.
2. Change the memory card.
3. Turn on the camera.
4. Use the data-transfer menu to remake the USB connection.
WINDOWS ME, 2000 PROFESSIONAL, AND XP
MACINTOSH
1. Stop the USB connection using the unplug-or-eject-hardware routine (p. 142).
2. Turn off the camera.
3. Change the memory card.
4. Turn on the camera.
5. Use the data-transfer menu to remake the USB connection.
1. Stop the USB connection by dragging the drive icon into the trash (p. 143).
2. Turn off the camera.
3. Change the memory card.
4. Turn on the camera.
5. Use the data-transfer menu to remake the USB connection.
Mac OSX
Windows XP
Mac OS
The volume name varies between memory cards.
Mac OSX
Windows
To Next Page
Loading...
