Press the shutter-release button partway down
(3) or press the central button of the controller
(4) to select the area; the other four areas will
disappear. Focus and exposure are locked when
the shutter-release button is pressed partway
down. Press the shutter-release button all the way down to
take the picture.
Once a focus area is selected, it will remain active even after
the picture has been taken. Only when a focus area has been
selected, can the controller be used to operate the zoom.
52
A
UTO-RECORDING MODE - ADVANCED OPERATION
Individual focus areas can be selected. Press and hold the central button of the con-
troller (1) until the Area-AF frame lines change to the spot-focus-area display. Press
and hold the controller again to return to the Area-AF frame lines.
Focus area selection
1
Use the four-way key of the controller (2) to highlight the
desired autofocus area; the active area is blue.
2
4
Press and hold the central button of the controller about one second to return to the
Area AF focus frames. To use another focus area, repeat the procedure.
3
To Next Page
Loading...
