DETAILED
OPERATION
99
Turn the function dial to .
While pressing the function
button, turn the control dial
until and appear
on the camera’s data panel.
Attach the flash to the cam-
era.
• The camera and flash should be on.
• Turning off the main switch of the camera with the accessory flash
attached also cancels wireless flash. If the flash is not attached, the flash’s
wireless/remote function will not be canceled. If this happens, see the
flash’s instruction manual to cancel the function.
Detach the accessory flash.
Canceling Wireless/Remote Flash Mode
1
3
4
2
98
Press the shutter-release button all the way down to
take the picture.
3
Wait until both flash units are fully
charged.
• appears in the viewfinder when the built-in flash is
charged.
• When the wireless/remote flash is charged, on the
rear of the flash is lit.
• Pressing the spot-AE lock button will test fire the
accessory flash. If the accessory flash does not fire,
change its position.
• To test fire the accessory flash, custom 10 should be
set to 1 (p.110).
2
WIRELESS/REMOTE FLASH
To Next Page
Loading...
Need help?
General
