7170
Press the spot/AE lock button to test fire the accessory flash.
FLASH – Wireless/Remote Flash
3. Press the shutter-release
button all the way down to
take the picture.
2. Wait until both flash units are
fully charged.
• appears in the viewfinder when the built-
in flash is charged.
• When the off-camera flash is charged, its
AF illuminator will blink.
Press the flash-mode button when taking the picture. Both flashes
will fire when the shutter is release at a 2:1 ratio. The built-in flash
will provide 1/3 and the accessory flash will provide 2/3 of the total
exposure.
Wireless/Remote Ratio Flash
CAUTION: Set CUSt – 8 (Spot/AE Lock) to setting 1
when Wireless/Remote flash mode is on. If
setting 2 is selected, test firing the flash will
activate slow-shutter sync (p82).
FLASH – Wireless/Remote Flash
Taking Pictures in Wireless/Remote Flash Mode
The off-camera flash will provide all of the exposure.
1. Position your camera and 3500xi flash unit using the
information on this page.
• If you are not using the 3500xi flash, refer to your flash instruction manual for
the correct camera to subject and flash to subject distances.
Aperture Camera – Subject Distance 3500xi – Subject Distance
f/2.8 1.4 – 5.0m (4.6 – 16 ft.) 1.0 – 5.0m (3.3 – 16 ft.)
f/4.0 1.0 – 5.0m (3.3 – 16 ft.) 0.7 – 4.5m (2.3 – 14.5 ft.)
f/5.6 1.0 – 5.0m (3.3 – 16 ft.) 0.5 – 3.2m (2.3 – 10.5 ft.)
• Calculated for ISO 100 film only.
To Next Page
Loading...
